||Home | The Foam Slipper
form will fit different feet sizes. You adjust size after needle felting by stretching
or shrinking while wet. The slipper was taken off the form after needle felting
and wet felted to give a firmer finish. I put the slipper on my hand, wet it with
warm water and use bar soap to rub until firm. Check for size as you are wet felting. Form length is 9 1/2 inches, 8 inches tall, 2 3/4 wide. Originally sold as a pair but most wanted only one so price has been reduced to one form. If you want a pair to work on both slippers together, order 2 at $8.00 each. Instructions included. 1 form $8.00 |
The Foam Mitten form is used the same as the Slipper form. Needle felt all sides of the mitten to finished stage, then remove and stretch or wet felt to get correct size. The form is 10 3/8 inches long by 7 inches across to thumb, 3/4 inch deep. Instructions included. Originally sold as a pair but most wanted only one so price has been reduced to one form. If you want a pair to work together, order 2 at $5.00 each. 1 form $5.00 |  |
 | The darner is inside the sock and fiber ready to layer over the hole in the sock heel. |  | This sock had a really large area with holes and on the inside you see a sizable patch of fiber that was needled first then wet felted under the kitchen faucet to make it thinner. |  | The same sock but on the outside, you can hardly see the added fiber. |
 | 3 Felting
Needles in a snap open case, all $3.50 for case of 3 needles
of the same size choose: 36 gauge triangle for general felting. 38 gauge star point has more sides, faster than 36, more resistant to breaking than 40. 40 gauge triangle is for fine fiber and detail. Felting tools information |
